Written Instructions on How to Clean and Do a Hot Tub Water Change

  1. Pick a time to clean the tub when it is warm enough to avoid pipe freezing and ice damage *WARNING: When tempatures are at freezing the pipes may become damaged if the power is off and the water is not heated
  2. Power off the hot tub and keep it powered off until the hot tub is full of water again *WARNING: Running the tub with low or no water will cause damage
  3. Remove the filters and drain all water out of the tub
  4. Using water rinse the filters to remove bigger particles
  5. Use a cartridge/filter cleaner to clean the filters
  6. Mix cleaning solution by following the manufacture’s directions
  7. Add filters to solution and let them soak according to the cleaning solutions directions
  8. Wipe the inside of the tube with a soft cloth and a mild none abrasive soap
  9. Fill the tub up until it is full
  10. Reinstall the clean filters
  11. Turn the power on using the disconnect
  12. Reprogram the hot tub controller for correct date, time, etc

 

Now the hot tube is clean, it should not need to be cleaned for a good 3 months depending on usage. Every 2 weeks or so clean the filters by spraying them with water.

 

Advertisement